Home | Online SuperStore | Information | Starter Kits | New Karters | Product List | Directions | Contact TS Racing
Longacre Racing Products, Inc.
14269 NE 200th ST. Woodinville, WA 98072
Phone 425 485 0620 Fax 425 485 0823 Orders 800 423 3110
Instructions for Caster/Camber Gauge
Always read at the center of the bubble.
Camber is marked in 1/4° + and - .
Turn wheels 20° to R & L when setting caster.
Find a flat, level place to set up your front end.
Attach the gauge to the spindle. If you have a magnetic adapter, be sure that the surface you attach to is machined square to the spindle and doesn’t have any nicks or burrs.
With the thread-on type adapter be certain the spindle threads are free of burrs. Usually there are a few extra threads on the spindle. If not, you will need to remove the spindle nut and install the adapter in its place.
Rotate the gauge until the small vial at the end of the gauge shows level.
Read the camber directly on one of the two vials on either side of the gauge. Note that they are marked + and - . Read the line nearest to the center of the bubble. Each line is 1/4° .
To read caster first turn the wheels 20° out so that the front of the tire is farther from the car. If you don’t have a set of turning plates you can use the angles machined on the corners of the gauge. Turn the wheels so that the angle near the adapter end is square with the side of the car and the angle at the other end is parallel to the side of the car. Rotate the gauge until it is level.
Turn the knurled knob in the center until the caster part of the gauge reads 0° . Now turn the wheels back to 20° the opposite way. Rotate the gauge again to level and read the caster on the center vial (read to the center of the bubble). Each line is 1/2° .
Adjust the caster and camber as needed. Each time you make a change bounce on the front end to settle the suspension. Remove the gauge and reinstall the spindle nut as needed.
Note: Adjusting the caster may have an effect on the camber and vice versa. Double check all your settings before finishing. Be sure to tighten all suspension bolts when done.
For more information contact:
TS Racing, Inc. 123C West Seminole Ave. Bushnell, Fl. 33513 USA (352)793-9600 email: info@TSRacing.com
Design by B/Z Technologies
Comments to: Webmaster@bztec.com
© 2000 - 2012 B/Z Technologies. All rights reserved.