Bleeder Kit for MCP and Enginetics Only
See directions in "More Details".
See directions in "More Details".
Directions for using brake bleeder bottle.
1. Remove filler plug from master cylinder.
2. Fill master cylinder reservoir to approximately 1/16" from bottom of filler plug hole.
3. Install bleeder adaptor in top of master cylinder cap.
4. Tighten all bleed screws, then open them 1/2 to 3/4 turn.
5. Place nozzle of bleeder bottle on the bleed screw of master cylinder adaptor and gently squeeze bottle to force fluid through the system.
6. When the fluid comes out of the caliper bleed screws without air bubbles, tighten them.
7. Remove the bleeder bottle.
8. Re-check the reservoir level and set to correct 1/16" below hole level.
9. Re-install the filler plug.
1. Remove filler plug from master cylinder.
2. Fill master cylinder reservoir to approximately 1/16" from bottom of filler plug hole.
3. Install bleeder adaptor in top of master cylinder cap.
4. Tighten all bleed screws, then open them 1/2 to 3/4 turn.
5. Place nozzle of bleeder bottle on the bleed screw of master cylinder adaptor and gently squeeze bottle to force fluid through the system.
6. When the fluid comes out of the caliper bleed screws without air bubbles, tighten them.
7. Remove the bleeder bottle.
8. Re-check the reservoir level and set to correct 1/16" below hole level.
9. Re-install the filler plug.
